Teledyne LeCroy WaveRunner XI SERIES Operator’s Manual - Manual (Page 45)

O
PERATOR
’
S
M
ANUAL
Restoring Software
Restarting the Application
Upon initial power-up, the oscilloscope will load the instrument application software automatically. If you exit the
application and want to reload it, touch the shortcut icon on the desktop:
.
If you minimize the application, touch the appropriate task bar or desktop button to maximize it:
.
Restarting the Operating System
If you need to restart the Windows® operating system, you will have to reboot the oscilloscope by pressing and
holding in the power switch for 10 seconds, then turning the power back on.
CONNECTING TO A SIGNAL
ProBus Interface
LeCroy's ProBus probe system provides a complete measurement solution from probe tip to oscilloscope display.
ProBus allows you to control transparent gain and offset directly from your front panel. It is particularly useful for
voltage, differential, and current active probes. It uploads gain and offset correction factors from the ProBus
EPROMs and automatically compensates to achieve fully calibrated measurements.
This intelligent interconnection between your instrument and a wide range of accessories offers important
advantages over standard BNC and probe ring connections. ProBus ensures correct input coupling by auto-
sensing the probe type, thereby eliminating the guesswork and errors that occur when attenuation or amplification
factors are set manually.
Auxiliary Output Signals
In addition to a calibration signal, the following signals can be output through the AUX OUTPUT connector:
Square Wave
Trigger Out – can be used to trigger another oscilloscope
WRXi-OM-E Rev C
45