Adding printers and drivers, Changing the default printer, Managing files – Teledyne LeCroy WaveRunner XI SERIES Operator’s Manual User Manual

Page 84: Hard disk partitions, 100base-t ethernet connection, Connecting to a network, Communicating over the network, File and printer sharing over a network, 100b, Thernet

AVE

UNNER

ERIES

Adding Printers and Drivers

Note: If you want to add a printer driver, the driver must first be loaded on the oscilloscope.

1. In the menu bar, touch

File, then Print Setup... in the drop-down menu. The Utilities Hardcopy dialog opens.

2. In the dialog area, touch the

Printer icon

3. Touch

the

Add Printer button. An MS Windows® window with which to add a printer will open.

mber of copies.

ult Printer

1. Minimize the instrument application by touching

File in the menu bar, then Minimize in the drop-down menu.

en.

ter, then touch

File, Set as Default Printer.

n USB memory, internal hard drive or network drives. You

rd drive to floppy disk. You also can give your files custom names and create

ent's hard disk is partitioned into drive

C: and drive D:. Drive C: contains the Windows operating

the instrument application software. Drive D: is intended for data files.

ETHERNET CONNECTION

Use the Ethernet connector (item

5 in the rear panel diagram) to connect the instrument to a network.

4. Touch the Properties button to change printer properties such as nu

Changing the Defa

If you want to change the default printer:

2. Touch

the

Start button in the task bar at the bottom of the scre

3. Select

Settings Æ Printers.

4. Touch the printer you want to set as the default prin

Managing Files

Use the instrument's utilities to create waveform files o
can copy files from your ha
directories for them.

Hard Disk Partitions

The instrum
system and

100BASE-T

Connecting to a Network

Communicating over the Network

ment uses Dynamic Host Configuration Protocol (DHCP) as its addressing protocol. Therefore, there is

nter Sharing:

derlying desktop.

2. From the toolbar select

Start Æ Control Panel Æ Network Connections Æ Local Area Connection.

The instru
no factory set IP address.

File and Printer Sharing over a Netwo

By default, this feature is disabled. To re-enable network File and Pri

1. Minimize the oscilloscope application to reveal the un

WRXi-OM-E Rev C