Teledyne LeCroy WaveRunner XI SERIES Operator’s Manual - Manual (Page 189)

O
PERATOR
’
S
M
ANUAL
WRXi-OM-E Rev C
189
You can also start with True and convert to False, but in this case overflows will cause an error message.
rument. This feature is intended for
rray and OutResult.DataArray are only to be used as shown in the default scripts and in the
rectly to individual elements of these arrays. You have to use your own
dData and newDataArray. You are not allowed to write statements like the
ot be changed because they are a part of the interface. These are
utResult and InResult objects
ts = endData - startData
edD = InResult.DataA ay (False
ort raw data
rface. The names must be retained. Furthermore,
ts, and their values cannot be changed. OutResult.Samples
puts, and can be changed, but not directly through their individual elements.
Anything after a single quotation mark on a line will not be used by the inst
comments, for example
' This is a comment.
A = Amp * Sin(Omega * T) Calculate the output.
InResult.DataA
example scripts: you cannot refer di
arrays, in this example, unscale
following:
Y = InResult.DataArray (17)
OutResult.DataArray (257) = Z
Some parts of the default script must n
highlighted in the following script .
' TODO add your custom code here accessing O
' Here's a small example that just inverts the waveform.
OutResult.Samples = InResult.Samples
startData = 0
endData = OutResult.Samples
newNumPoin
ReDim newDataArray ( OutResult.Samples)
unscal ata rr )
For i = 0 To endData - 1
newDataArray (i) = - unscaledData (i)
Next
OutResult.DataArray (False) = newDataArray _ ' only supp
The four highlighted quantities are parts of the inte
InResult.Samples and InResult.DataArray are inpu
and OutResult.DataArray are out