Edge trigger setup, Channel setup – Teledyne LeCroy WaveRunner XI SERIES Operator’s Manual User Manual
Page 62

W
AVE
R
UNNER
X
I
S
ERIES
Alternatively, in the
Trigger dialog, you can touch inside the Level field and type in a value, using the pop-up
numeric keypad. To quickly set a level of zero volts, touch the
Zero Level button directly below the Coupling
field.
An arrow on the left side of the grid shows the threshold position. This arrow is only visible if the trigger source is
displayed.
Edge Trigger Setup
C
HANNEL
S
ETUP
1. In the menu bar, touch
Trigger, then select Trigger Setup... from the drop-down menu.
2. Touch
the
Edge trigger button
under the
Trigger tab.
3. Touch
inside
the
Trigger Source field and select an input from the pop-up menu.
4. Touch
inside
the
Level field:
5. In the pop-up numeric keypad, enter a value in millivolts or use the up/down buttons to increase or decrease
the value in increments of 1 mV. Or, touch one of the preset value buttons:
6. Select the holdoff by touching the
Time or Events buttons
,
7. Using the pop-up numeric keypad, enter a value and specify the unit of time:
8. Or, use the up/down buttons to increase or decrease the time value in increments of 100 µs. Or, touch one of
the preset value buttons:
62
WRXi-OM-E Rev C