Clear-Com CellCom Battery Pack Charger - Manual (Page 97)

Clear-Com Communication Systems
CellCom V2.0.3 Instruction Manual
5 - 2 7
SYSTEM INFO (“INFO”)
When INFO is selected the screen displays the system’s current
firmware version, DECT system ID (for registering beltpacks), and if
applicable, IP address.
Figure 5-62: System Info Menu
To return to the SYSTEM menu, press the setup/enter button.
RESTORING THE DEFAULTS (“DEFAULT”)
When F.DEFAULT is selected the factory default map is loaded into
memory, the IP address is set to 172.30.3.100 and the IP mask is set
to 255.255.0.0
Note: The F.DEFAULT feature will only work on Basestations that
have been upgraded by ClearCom or a qualified ClearCom
representative.
Figure 5-63: Restore Defaults Menu
ANTENNAS (“ANTENNAS”)
When ANTENNAS is selected the display shows the status of the
active antennas that are connected to the basestation, and shows the
slots on each antenna that are occupied by beltpacks. This information
may be useful during a site survey, or when troubleshooting coverage
areas or antenna connections.
A typical display is shown below:
Figure 5-64: ANTENNAS menu
The numbers 1 through 10 represent the maximum number of
antennas that can be connected to the basestation. Numbers 1
through 5 can be positions on a splitter connected to transceiver port 1,
BUILD: JAN 21 2009 17:29:37 V2.0.0.037 => NEW FROM A
SYSTEMID: 100EC012 (A11)SYS:1 IPADDRESS: 129.67.61.36
CARRIERS: 0000 000300 RAM: 16MB FPGA:2.1
COPYRIGHT 2004-2008 VITEC GROUP COMMUNICATIONS
Select map...
F.DEFAULT USER MAP BACK
1> ---- ---- ---- ---- ----
2> ---- ---- ---- ---- ----
3> 2 4 ---- ---- ----
4>
5> SYSTEM: 1
TOTAL ONLINE: 4 6> 1 ---- ---- ---- ----
7> 3 ---- ---- ---- ----
8>
9>
10>