Clear-Com CellCom Battery Pack Charger - Manual (Page 142)

Clear-Com Communication Systems
CellCom V2.0.3 Instruction Manual
8 - 6
PD2203 FRONT CONNECTOR PANEL
Figure 8-3: CellCom Splitter Front Connector Panel
Basestation Connection Indicator Light
This yellow light indicates that the PD2203 splitter is receiving data
from the CellCom basestation.
Matrix (CellCom Basestation) Connector
This RJ-45 connector accepts a 4-pair data cable from the CellCom
basestation transceiver port. This cable can be up to 1,000 meters
(3,200 feet) in length if 24AWG cable is used or up to 500 meters
(1,600 feet) if 26AWG cable is used.
Note: It is recommended that shielded CAT-5 cable is used.
Splitter-to-Transceiver/Antenna Signal Indica-
tor Light
These yellow lights indicate that a connection from the CellCom
basestation is available to the particular transceiver connected to that
port.
Transceiver/Antenna Connectors
These five RJ-45 connectors are used to connect up to five remote
transceiver/antennas to the splitter, and via the splitter to the CellCom
basestation. Each of these cables can be up to 1,000 meters in length
if 24 AWG cable is used or up to 500 meters long if 26 AWG cable is
used.
Note: It is recommended that shielded CAT-5 cable is used.
1
2
3
4