Clear-Com CellCom Battery Pack Charger - Manual (Page 158)

Clear-Com Communication Systems
CellCom V2.0.3 Instruction Manual
1 0 - 6
UPLOADING CONFIGURATIONS USING THE SERIAL
LINK
To send an edited configuration back to the basestation using the
serial link, re-connect the basestation (if it has been disconnected) and
ensure that at least 30 seconds have elapsed since basestation
power-up to allow serial comms to be activated, then click the ‘Apply’
button in the ‘Serial comms’ area. Transfer should take around 1 min.
15 secs. If it is required that the basestation is reset after the the map
is uploaded the ‘Reset On-Apply’ checkbox should be checked. If this
is the done the basestation will reboot and the levels will be reset to the
default levels If a reset is not requested the map will be applied but the
levels will not be reset to the defaults.
UPLOADING CONFIGURATIONS USING ETHERNET
To send an edited configuration back to the basestation ensure that
there is an ethernet link and click the ‘Save &Apply’ button in the ‘LAN’
area. Transfer should normally take a few seconds. If it is required that
the basestation is reset after the the map is uploaded the ‘Reset
On-Apply’ checkbox should be checked. If this is the done the
basestation will reboot and the levels will be reset to the default levels
If a reset is not requested the map will be applied but the levels will not
be reset to the defaults.