The set defaults button, Read beltpack settings, Write beltpack settings – Clear-Com CellCom Battery Pack Charger User Manual
Page 162: Remember my default settings, The set defaults button -10, Read beltpack settings -10, Remember my default settings -10, Figure 10-14 beltpack defaults setup -10
Clear-Com Communication Systems
CellCom V2.0.3 Instruction Manual
1 0 - 1 0
THE SET DEFAULTS BUTTON
The ‘Set Defaults’ button opens the beltpack defaults configuration
screen. This allows the beltpack defaults to be configured and
downloaded to a beltpack using the beltpack serial cable. Beltpack
defaults can also be read back from a beltpack, the default settings
can be saved and restored in the editor and factory default settings
recalled.
Figure 10-14: Beltpack Defaults Setup
To use the beltpack defaults facility the beltpack should be connected
to the PC using the beltpack serial cable and the beltpack switched on.
Read Beltpack Settings
This button causes the configuration editor to read back the default
settings from the connected beltpack and display them in the settings
area.
Note: The settings read back are NOT the same settings entered
via the beltpacks menu options.
Write Beltpack Settings
This button causes the configuration editor to write the settings
displayed on the the configuration editor to the connected beltpacks
current and default settings.
Remember My Default Settings
This button saves the currently displayed default settings (of the config
editor) for later recall. This allows the user to ensure that all beltpacks
are set up to the same default settings if required.