Clear-Com CellCom Battery Pack Charger - Manual (Page 43)

Clear-Com Communication Systems
CellCom V2.0.3 Instruction Manual
2 - 1 1
CALLING THE WIRELESS PARTY LINE
FROM THE WIRED PARTY-LINE BELTPACK
1. From the basestation’s front-panel menu, select PORTS, then
PLCHA, then CALLS, then WP#01.
The changes are saved and applied automatically five seconds after
the last time the setup/enter knob is pressed or turned. The
front-panel display flashes to indicate that the changes are being
saved and applied.
2. After a few seconds talk from the wired beltpack’s microphone.
• Audio from the wired beltpack should be audible on the two
wireless beltpacks, and on the 4-wire audio device.
• Audio from the 4-wire audio device will be audible from the wired
beltpack’s headset.
3. If the basestation is powered down and then up again, the talk paths
from the wired beltpack (on party-line channel A) are re-established
to the 4-wire device and to the two wireless beltpacks.
4. It is possible to remove the talk paths from the wired beltpack’s party
line to the other devices by selecting PORTS, then PLCHA, then
CALLS, then NONE. This may also be done by disabling the party
line from the front panel of the CellCom basestation by using the CH
A and CH B enable buttons provided that the party line is powered
from the basestation as this will remove the power rather than the
audio. It will not remove the talk paths if the party line is externally
powered.