Creating a wireless party line – Clear-Com CellCom Battery Pack Charger User Manual
Page 40
Clear-Com Communication Systems
CellCom V2.0.3 Instruction Manual
2 - 8
• Audio from the wired beltpack should be audible on the two
wireless beltpacks, and on the 4-wire audio device.
On the wireless beltpacks. the green (listen) light should be
flashing, indicating an incoming call to group #1 from a member of
group #1.
• Audio from the 4-wire audio device will be audible from the wired
beltpack’s headset.
3. If the basestation is powered down and then up again, the talk paths
from the wired beltpack (on party-line channel A) are re-established
to the 4-wire device and to the two wireless beltpacks.
4. It is possible to remove the talk paths from the wired beltpack’s party
line to the other devices by selecting PORTS, then PLCHA, then
CALLS, then NONE. This may also be done by disabling the party
line from the front panel of the CellCom basestation by using the CH
A and CH B enable buttons provided that the party line is powered
from the basestation as this will remove the power rather than the
audio. It will not remove the talk paths if the party line is externally
powered.
CREATING A WIRELESS PARTY LINE
To create a wireless party line
1. From the basestation’s front panel, use the setup/enter knob to
scroll to and select GROUPS, then WP#01, then MEMBERS.
If entries in the MEMBERS menu are already in the wireless party
line these menu entries are outlined. An outline around a menu
entry means that it is a member of the wireless party line. When an
item is selected an outline appears around it. When the item is
selected again, the outline disappears.
2. Select the following members of the wireless party line: 4WIR1,
PLCHA, BPK01, BPK02, so that only these entries are outlined.
3. To exit the Wireless Party Line Members menu, scroll to and select
BACK from the basestation’s front-panel menu.
4. The changes are saved and applied automatically five seconds after
the last time the setup/enter knob was pressed or turned. The
front-panel display flashes to indicate that the changes are being
saved and applied.
ASSIGNING THE WIRELESS PARTY LINE
LABEL TO CELLCOM BELTPACK KEYS
The next step is to assign the wireless party line label created in the
previous step, WP#01, to the first key of each of the CellCom wireless
beltpacks.
To assign the wireless party line label to the first key of CellCom
beltpack #1