Appendix c: default beltpack settings – Clear-Com CellCom Battery Pack Charger User Manual
Page 207
Clear-Com Communication Systems
CellCom V2.0.3 Instruction Manual
A - 1
APPENDIX C:
DEFAULT BELTPACK
SETTINGS
The beltpack has 2 storage configurations for beltpacks settings.
The 1st is the DEFAULT area and the 2nd is the USER area.
The user may only edit the USER area.
On power up, only the USER area is retrieved and used.
The DEFAULT parameters can be copied to the USER area by
selecting the "Set Defaults" menu in the beltpack
Cellcom Freespeak Config Editor
When in the Config Editor and the "Set Defaults" is clicked. The
“Configure Beltpacks Defaults” window will display the last set of
DEFAULT parameters adjusted whilst in this window.
To read the DEFAULT settings from the beltpack you must connect the
serial cable and then click the "READ BELTPACK SETTINGS". The
config editor will then read the DEFAULT settings from the beltpack.