Clear-Com CellCom Battery Pack Charger - Manual (Page 111)

Clear-Com Communication Systems
CellCom V2.0.3 Instruction Manual
6 - 1 1
Figure 6-7: How the beltpack displays its six communication routes
The case of a label on the beltpack indicates its assignment type:
• All uppercase - Talk
• First letter in uppercase, rest lowercase - DTL
• All lowercase - Listen
To activate a talk or listen to an assigned source or destination (“label”)
1. Use the beltpack’s scroll buttons to scroll to the page on which the
desired assignment (“label”) appears. The beltpack holds three
pages of assignments. Each page displays two assignments.
As the display is scrolled “beeps” will be heard in the headset that
correspond to the page displaying on the beltpack: 1 beep for page
1, 2 beeps for page 2, etc.
2. When the appropriate page is reached select one or both of the
assignments on that page by depressing the corresponding talk
buttons on the beltpack (A or B).
3. Press and hold the appropriate talk button to talk or listen to the
destination. Release the button to close the talk or listen path.
Alternatively quickly tap the talk button to latch it “on”. Quickly tap it
again to release the latch.
4. To activate another communication route, repeat steps 1 through 3.
It is possible to keep all six communication routes “open” at the same
time. All activity on these routes will be heard in the headset.
Note: Two-wire and four-wire devices can have dual
talk-and-listen or just listen assignments.