Clear-Com CellCom Battery Pack Charger - Manual (Page 34)

Clear-Com Communication Systems
CellCom V2.0.3 Instruction Manual
2 - 2
To Connect to the CellCom Basestation to an Antenna
1. Connect a CAT-5 cable from transceiver port 1 on the CellCom
basestation’s rear panel to a CellCom antenna (connection 3). See
Figure 2-1 for an illustration (shielded CAT-5 is recommended).
2. Power up the basestation.
3. Power up the beltpacks.
If the beltpacks do not connect to the basestation within 30 seconds,
check that they are registered to the basestation. If they are not,
refer to the chapter “CellCom Configuration Editor” for instructions
on registering the beltpacks to the basestation.
Figure 2-1: Connect the CellCom Basestation to the Wired Devices
4. To get the CellCom into a “clean” state for the example below, from
the basestation’s front-panel display, scroll to and select PORTS,
then 4WIR1, then CALLS, then NONE. (NONE is the last element in
the list.) Then also select PORTS, then PLCHA, then CALLS, then
NONE (See Figure 2-2).
POWER PL CH-A PL CH-B PRGM IN SA OUT
SA RLY
4-WIRE / ECLIPSE PORTS
1 2 3 4
BASE LOOP LAN
PC PROGRAM
TRANSCEIVER
1 2
90-260V, 50/60Hz
80 Watts
1 2 3
CellCom Base Station Rear Panel
Connect XLR cable to
party-line beltpack Connect CAT-5 cable
to 4-wire audio source Connect CAT-5 cable to
CellCom antenna
Channel A
Eclipse Matrix
CellCom Antenna
Party-Line Beltpack
Always power up external
party-line equipment,
CellCom splitters, and
CellCom active antennas
before powering the CellCom
basestation.