Calling the wireless party line from the beltpacks – Clear-Com CellCom Battery Pack Charger User Manual
Page 41
Clear-Com Communication Systems
CellCom V2.0.3 Instruction Manual
2 - 9
1. From the basestation’s front-panel menu select BELTPACKS, then
BPK01, then KEYS. A list will be displayed showing how the 3
pages of 2 keys are currently assigned on beltpack #1.
2. Select “Pg1-1” to edit the first key of the first page. A list of
destinations will be displayed this key can be assigned to. Rotate
the setup/enter knob clockwise until “WP#01” is highlighted, then
press the knob to select it. The basestation’s display should display
the key options.
• TLK - talk key
• LIS - listen key
• T+L - talk and listen key
• DTL - dual talk and listen key
• FL - forced listen key
• TFL - talk and forced listen key
3. Select DTL using the setup/enter knob and press the knob to select
it.
4. Select BACK, then BACK again to return to the list of beltpacks.
5. The changes are saved and applied automatically five seconds after
the last time the setup/enter knob was pressed or turned. The
front-panel display flashes to indicate that the changes are being
saved and applied.
6. Repeat the procedure for beltpack #2.
CALLING THE WIRELESS PARTY LINE
FROM THE BELTPACKS
To call the wireless party line from beltpack #1
1. If beltpack #1 is not set to page #1 (indicated by the numbers in the
center of the display), use the beltpack’s left and right scroll buttons
to move to page 1.
The label under the left-hand rotary controller should now read
WPL01.
2. If the key is programmed to DTL on the basestation press the rotary
controller briefly to latch the listen path to “on” or press and hold the
rotary controller to talk.
• The red talk light and green listen light next to the rotary controller
should light.
• If the path is latched to Listen pressing and releasing the rotary
controller will delete the path and the red and green lights will
extinguish.
• If the rotary controller is being held to create a talk path releasing it
will delete the path. The red and green lights will be extinguished
when the talk path is deleted.