Loading a configuration from disk, Com port selection, Ip setup – Clear-Com CellCom Battery Pack Charger User Manual
Page 154: Link -2, Figure 10-2 map select screen -2
Clear-Com Communication Systems
CellCom V2.0.3 Instruction Manual
1 0 - 2
LOADING A CONFIGURATION FROM DISK
To load a configuration from disk, click the ‘Load’ button. A dialog box
will pop up, allowing the user to browse for the configuration file.
Configuration files end in a ".map" extension.
Figure 10-2: Map Select Screen
COM PORT SELECTION
The COM port drop-down box shows only those ports that are
available for connection to the basestation. If the required port is not
shown it may be that another program is using this port. Close the
other program down, and try again.
IP SETUP
The basestation IP address can be set in the configuration editor under
the ‘System’ tab and on the basestation via the ‘System’ menu. The
procedure for setting the basestation IP address using the
configuration editor is described in this chapter and the procedure for
setting up the IP address on the basestation is described in chapter 5.
RETRIEVING A CONFIGURATION FROM A CELLCOM
BASESTATION VIA THE SERIAL LINK
• Connect the PC to the basestation using a standard
Cellcom/Freespeak serial cable. Select the COM port that it is
connected to using the drop-down box in the "Serial comms"
section of the dialog. Power on the Cellcom/Freespeak
basestation and wait 30 seconds.