Clear-Com CellCom Battery Pack Charger - Manual (Page 75)

Clear-Com Communication Systems
CellCom V2.0.3 Instruction Manual
5 - 5
Figure 5-7: Second Beltpack Programming Menu
4. Scroll to and select LABEL from the menu.
A menu to edit the selected beltpack’s label appears, as shown in
Figure 5-8. The current 5-character label appears, just under its
generic name.
Figure 5-8: Editing a Beltpack’s Label
5. Scroll to and select the alphanumeric character to be changed. A
box appears around the character.
6. Rotate the setup/enter knob. As the knob is rotated the entire range
of available characters appears, starting with upper-case
characters, proceeding to lower-case characters, then to digits, and
finally to punctuation characters.
7. When the desired new character appears, press the setup/enter
knob to select it. The box disappears, and is replaced by the solid
highlight.
8. Repeat steps 4 through 6 for all the characters in the label that are
to be changed.
9. When editing the label has been completed, select BACK to return
to the PROGRAMMING OPTIONS menu.
10. The changes are saved and applied automatically five seconds
after the last time the setup/enter knob was pressed or turned. The
front-panel display flashes to indicate that the changes are being
saved and applied.
11. The beltpack that has had a new label assigned to it should be
power cycled to ensure it is updated with the new label.
To edit another beltpack label, scroll clockwise to the BACK command
and select it. The AVAILABLE BELTPACKS screen appears. Select a
new beltpack label to edit, and repeat steps 2 through 9.
SELECTED BPK01 - BPK01
REGISTER LEVELS BACK LABEL
Enter name for - BPKO1
A U D I O BACK
Port labels identify the
devices wired to the
basestation’s rear panel
ports.
Audio ports include headset,
4-wire, party line, stage
announce, and program
source labels.