Clear-Com CellCom Battery Pack Charger - Manual (Page 138)

Clear-Com Communication Systems
CellCom V2.0.3 Instruction Manual
8 - 2
Antennas with different coverage patterns (directional units) that are
appropriate for the 1.9 GHz range may be substituted for the provided
antennas, if variations in coverage pattern are required.
CEL-TA BOTTOM/CONTROL PANEL
Figure 8-2: CellCom Transceiver/Antenna Bottom/Control Panel
Serial Data Connector
This 3 mm (1/8 inch) tip-ring-sleeve (TRS) connector is used for
upgrading the firmware in the CEL-TA. It will typically be unused.
Data Signal LED
This amber LED indicates that a connection has been established
between the CellCom basestation and the transceiver/antenna, and
that it is actively creating a coverage zone within which the beltpacks
can operate. If it is off, check the cable connections at both ends, as
well as the powering.
When viewing an antenna status directly at the antenna, the amber
LED indicates that it is receiving a data link from the basestation,
however this does not guarantee that the rack end can receive data
messages from the antenna.
Matrix Connector
This RJ-45 connector is used to connect the bi-directional signal from
the CellCom basestation, directly or via the splitter. Up to 1,000 meters
1
2
3