Clear-Com CellCom Battery Pack Charger - Manual (Page 105)

Clear-Com Communication Systems
CellCom V2.0.3 Instruction Manual
6 - 5
the answer-back “talk” light illuminates to indicate an incoming call
(see description in “Beltpack Top Control Section” above).
BELTPACK BATTERIES
BELTPACK REAR/BATTERY SECTION
Figure 6-4: View of Back of Beltpack
Power Button
The recessed power button is used to turn the CellCom beltpack on
and off. Press and hold the button for about three seconds to turn the
unit on. To turn the unit off, again press and hold the button for about
three seconds.
Battery Case
The removable battery case will hold four alkaline AA or four NiMH
(nickel-metal hydride) rechargeable batteries. These batteries
alternate, with the negative pole contacting the spring and the positive
pole contacting the plate inside the case.
To remove the battery case, press on the top of the belt clip to lift it off
the case, and with the thumb and middle or ring finger of the other
hand squeeze the side tabs of the case and lift it out, slightly tilting the
lower (toward the bottom of the beltpack) portion of the pack out first.
To insert the battery pack, follow the above instructions in reverse.
Note that the battery case has a clip-on lower cover; make sure to put
it back in place before putting the battery case back into the beltpack.
1
2