Clear-Com CellCom Battery Pack Charger - Manual (Page 76)

Clear-Com Communication Systems
CellCom V2.0.3 Instruction Manual
5 - 6
SETTING AND CHANGING PORT LABELS
Port labels are created to identify the audio devices wired to the
basestation’s rear panel ports, such as party-line beltpacks, 4-wire
devices, program sources, and stage-announce outputs and relays.
To create a port label
1. From the basestation’s MAIN menu, scroll to and select PORTS
(see Figure 5-9).
Figure 5-9: Select “Ports” from the Main Menu
The first AVAILABLE AUDIO PORTS menu is displayed, as shown in
Figure 5-10.
Figure 5-10: First Available Ports Menu
The first page of the menu shows the first 5 ports, starting with
HDSTA (front-panel headset A) and continuing through 4WIR3 (the
third 4-wire connector on the rear panel), as shown in Figure 5-10.
By scrolling all the way to the right, and then continuing to scroll,
4WIR4 through PRGRM (program) will be displayed (Figure 5-11).
Figure 5-11: Second Available Ports Menu
Note: The upper character of the pair is a generic label, while the
lower character is editable.
2. Select an audio port from the menu. A screen appears that gives the
options for programming the selected port, as shown in Figure 5-12.
Figure 5-12: Port Programming Options Menu
MAIN MENU
GROUPS BELTPACKS SYSTEM PORTS
AVAILABLE AUDIO PORTS
HDSTB
HDSTB 4WIR1
4WIR1 4WIR2
4WIR2 4WIR3
4WIR3
BACK
HDSTA
HDSTA
AVAILABLE AUDIO PORTS
PLCHA
PLCHA PLCHB
PLCHB STGAN
STGAN PRGRM
PRGRM
BACK
4WIR4
4WIR4
SELECTED HDSTA - HDSTA
LEVELS KEY BACK LABEL
GROUPS
The upper label retains the
same generic label, while
the lower label can be edited
to the user requirements.