Burkert Type 8620 - Manual (Page 45)

mxCONTROL Type 8620
Page 45
11.4 Configuration and Parameterization
11.4.1 Preface about Configuration/Parameterisation
The configuration (Code Level: Specialist) can be done with a special configuration file (XML
style), which can be downloaded into the „Type 8620 mxCONTROL“ from an SD card or via USB.
This configuration file will be generated with a special PC Tool.
Figure 11: Diagram of the upload and download of configuration and parameter files
This procedure allows an identical configuration of many „Type 8620 mxCONTROL“ devices. It is
also possible to upload a current configuration file from the „Type 8620 mxCONTROL“.
The parameterization can be done separately in the same way.
It is possible to change only the parameterization in the parameter file, e.g. for optimizations and
download it into the device.
Furthermore, the „Type 8620 mxCONTROL“ can be parameterized by using the soft keys. It is also
possible to upload the current parameters from the „Type 8620 mxCONTROL“.
Firmware updates are handled only via USB.
11.4.2 Operating Language
Pre-selection of the operating language is done in the configuration file. The language can also be
changed by an operator in the System settings menu at the device. Available are the languages
English, German, French
.
11.4.3 Factory Setting of Parameters and Factory Reset
The command “Factory Reset” deactivates (deletes) the current configuration and parameteri-
zation.
Also the all the parameters and the codes are reset to default values.
Further operation of the „Type 8620 mxCONTROL“ is only possible after downloading a configuration
and parameter file via SD card.
"Factory Reset" is a submenu of the main menu item "System Settings". It is password-protected
(CodeLevel: Specialist).