Burkert Type 8620 - Manual (Page 35)

mxCONTROL Type 8620
Page 35
Changing Passwords
→ Choose the main menu item “Configuration”, enter with “ENTER”
→ Enter the specialist password (by possibly pressing the "+" key several times; you can also use
the "<-" for multi-digit numbers), then press "OK".
→ Scroll for Menu item “Codes” with the “Arrow”-keys, enter with “ENTER”
→ Choose the Operator or Specialist Level which shall be changed, then press key “INPUT”
→ Input the specialist code by pressing the key “+” the required number of times, then press “OK”
→ Set a new value for the code by pressing the key “+” (for multi-digit codes use also the key “<-“),
then press “OK”.
If the menu item was left by pressing key “ESC” the new value is not accepted!
→ Leave the Menu item “Codes” by pressing “EXIT”