Burkert Type 8620 - Manual (Page 144)

mxCONTROL Type 8620
Page 144
15.2 Displaying (Input-) Alarms and different
(Output-) States
The input alarms and output states are displayed in the "Process data" main menu in the "Input" submenu items
and in the submenus of the corresponding modules.
Display
Input State
AL Lower Alarm FS Sensor Fault
AH Higher Alarm FA AD-Fault
WL Lower Warning FC Configuration Fault
WH Higher Warning Fc Calibration Data Fault
FI Input Fault nA Input not active
OK
Output status or output is calculated/impacted by:
Au Automatic Mode fo an other module
Ma Manual Mode fF (active) Flow-Switch
OF 4…20 mA Output error fS (active) System
YA ASL-Pump-Stop Switch
YS Safety control output (CMDsafe) Fc Calibration Data Fault
is active (only in menu “Out-
YF Out fails (MOT is expired) puts” for 4-20 mA
outputs)
Additionally the following icons are displayed in parent menus for easy alarm / warning identification:
Icon Priority Description
A! 1 (High) There is at least one alarm in the submenus.
W 2 There is at least one warning in the submenus
! 3 There is at least one configuration error in the submenus
4 (Low) OK
Only the item with the highest priority is displayed, if there is a mixture of alarms / warnings / configuration errors
in the submenus.