Atec Agilent-8563E - Manual (Page 33)

Service Software ESG Family Signal Generators
ESG Family Support Software Administration
3-12 Calibration Guide
Adding Device Drivers
Follow these instructions to add test equipment device drivers to the program:
CAUTION This and the following procedures: Adding/Removing Device (Test
Equipment) Drivers, Adding/Removing Test Drivers, and Adding/Removing
Datapacks are included for informational purposes. These procedures should
only be used when instructions are provided describing which drivers or
datapacks need replacement or removal.
1. Log into the software normally until the Select Test Equipment and Tests window is
displayed.
2. Click the Cancel button to close the Select Test Equipment and Tests window.
3. Refer to Figure 3-6 . In the File drop-down menu, select Test Equipment Drivers.
Figure 3-6 Test Equipment Drivers in the File Drop-Down Menu
This selection allows for the addition or removal of software drivers for the test
equipment being used to verify the performance of the DUT.
4. To add a device driver to the existing list of test equipment drivers, click Add
( Figure 3-7 ).