Printronix P7000 Cartridge Ribbon Printer - Manual (Page 79)

OpenPrint P7000 HD Postscript/PDF Firmware
79
ZTP TearDist
This option sets the tear off distance from the current print position to the tear
bar. Adjustable values in increments of 1/144th of an inch range from 200 to
2880. The up and down arrows adjust the display value. When you press the
ENTER
key, the selected value is stored and a scale is printed to indicate the
current tear off position. The default value is 1060.
NOTE: When a new value is selected, the printer will lose the current print
position. You must reset the top of form to automatically save the new
value.
Active Emulation
The Active Emulation menu enables you to select a combination of
emulations as described in Table 2 on page 61.
Active IGP Emulation
The Active IGP Emulation menu enables you to activate either the PGL or
VGL emulation. This menu is only available with the P7000 STD and TN
firmware as described in Table 2 on page 61.
PGL SFCC
You can specify which hex code (1-FF) will be used as the Special Function
Control Character (SFCC). The SFCC denotes that the following data is an
IGP command.
• 7E (default)
• 1 – FF
VGL SFCC
You can specify which hex code (1-FF) will be used as the Special Function
Control Character (SFCC). The SFCC denotes that the following data is an
IGP command.
• 5E (default)
• 1 – FF
Printer Protocol
Select the LinePrinter+ protocol you wish to use. Refer to the LinePrinter Plus
Programmer's Reference Manual for more information.
Form Length
Form length is the number of lines that can be printed on a page. You can set
the form length in inches, millimeters (mm), or as a function of the current lpi
(lines per inch).
QUICK SETUP Menu