Printronix P7000 Cartridge Ribbon Printer - Manual (Page 160)

160
Chapter 4 LinePrinter Plus Emulation (With PCL-II)
Host Command
This parameter allows you to block certain host commands from being
acknowledged by the printer.
• Enable (default). All host commands are acknowledged by the printer.
• Ignore All . All host commands are ignored by the printer.
• Ignore CPI . All CPI commands sent by the host are ignored by the
printer.
• Ignore LPI . All LPI commands sent by the host are ignored by the printer.
• Ignore Unidir . All Unidirectional commands sent by the host are ignored
by the printer.
Font Attributes
Typeface
• Data Processing (default). A general purpose font printing out at
120 dpi horizontally and 72 dpi vertically. The width of the font will vary
with each cpi.
• NLQ . A high quality font printing at 180 dpi horizontally and
96 dpi vertically. This font has serifs and the width of the font varies with
the cpi.
• OCR-A / OCR-B . Optical character recognition fonts printing at 120 dpi
horizontally and 144 dpi vertically. Both fonts print only at 10 cpi.
• High Speed . A draft quality font printing at 120 dpi horizontally and 48 dpi
vertically. The width of the font varies with the cpi.
• NLQ Sans Serif . A high quality font printing at 180 dpi horizontally and 96
dpi vertically. This font prints without serifs. The width of the font varies
with the cpi.
• High Speed 100 . A draft quality font printing at 100 dpi horizontally and
48 dpi vertically. When chosen from the front panel, it defaults to 10 cpi.
The cpi can then be varied, but the width will not change.
• NLQ 200 . This NLQ font prints at 200 dpi horizontally and 96 vertically.
When chosen from the front panel, it defaults to 12 cpi. The cpi can then
be varied, but the width will not change.
• DP 200 . This Data Processing font prints at 200 dpi horizontally and 72
vertically. When chosen from the front panel, it defaults to 12 cpi. The cpi
can then be varied, but the width will not change.
• High Speed 64 . This font prints at 120 dpi horizontally and 64 vertically.
When chosen from the front panel, it defaults to
10 cpi. The cpi can then be varied, but the width will not change.
• BARCODE 145 . This Data Processing font prints at 145 dpi horizontally
and 72 vertically. When chosen from the front panel, it defaults to 12 cpi.
The cpi can then be varied, but the width will not change.
• BARCODE 160 . This Data Processing font prints at 160 dpi horizontally
and 72 vertically. When chosen from the front panel, it defaults to 13 cpi.
The cpi can then be varied, but the width will not change.