Printronix P7000 Cartridge Ribbon Printer - Manual (Page 258)

258
Chapter 4 ADVANCED USER Menu
Power Saver Time
The time interval you specify for this parameter sets the amount of idle time
before the printer goes into Power Saver mode. When Instant is chosen, the
printer goes into Power Saver mode as soon as it is able to stop the shuttle
properly. The time allotted to perform this function depends upon the shuttle
timeout value which can be set in the menu.
NOTE: Power Saver Mode will not be shown on the control panel even
though the function still exists. Sending a print job to the printer will
turn off Power Saver mode.
Pwr Save Control
Allows you to enable or disable the Power Save (Energy Star) mode.
• Enable (default). Allows you to enable the Power Save (Energy Star)
mode.
• Disable . Allows you to disable the Power Save (Energy Star) mode.
Cancel Key
• Disable (default)
• Enable . The CANCEL key may be used to clear all data in the print buffer
without printing any of the data.
Rcv. Status Port
This option defines the interface being used to receive the emulation status
command.
• Automatic (default). When selected, the status command is sent to the
printer with the print data through the active host interface.
• Serial . When selected, the status command is sent to the printer through
the serial interface regardless of the active host interface.
Ret. Status Port
This option selects the port for the Return Status Commands (i.e., ~STATUS
(PGL) and ~HS (ZGL)) to send the status data back to the Host.
The options are Automatic (factory default), Serial, E-NET Stat Port,
IEEE 1284, Disable, and E-NET Data Port.