beautypg.com

Graphic chek cod, Lac option, Lac approx – Printronix P7000 Cartridge Ribbon Printer User Manual

Page 139: Set text orientn, Host override

background image

Twinax Params

139

Graphic Chek Cod

Specifies the replacement character to print in place of any unprintable
character that is received from the host. Choose a hex character from 40
through FE. The character becomes the printer default when:

the printer is powered off and then powered on;

an SGEA command specifies to use the operator panel default;

the Graphic Chek Err parameter is disabled.

LAC Option

Allows the host system to load alternate character images into the printer.
This may be used for designing graphics, barcodes, and charts, or for printing
in foreign languages.

Enable

(default). Prints the LAC character as defined.

Disable

. Ignores the LAC definition from the host and prints from the

currently selected character set.

LAC Approx.

A process that reorganizes columns of dots so that clean, readable printing is
possible.

On

(default). Converts the emulated character cells to standard cells for

the P7224 model.

Off

. Converts character cells byte by byte and not by LAC approximation.

Set Text Orientn

Specifies the direction in which characters are printed on the page. This
allows the printer to print languages that are printed right to left instead of left
to right. The options include:

Control By Host

(default)

Left to Right

Right to Left

Host Override

Determines whether the printer accepts certain commands sent by the host or
continues to use the current operator panel settings.

Disable

(default). Allows the following host commands to override

operator panel settings: line length, forms length, lines per inch (LPI),
characters per inch (CPI), print quality, and text orientation. Note the
information appearing on the message display may not match the data
stream setting. No values will change upon initial selection of the disable
option.

Enable

. The operator panel settings override the host commands.

NOTE:

Host margin and tab settings will take precedence whether or not
Host Override is enabled.