Printronix P7000 Cartridge Ribbon Printer - Manual (Page 305)

Fault Messages
305
ETHERNET ADAPTER
BEING INITIALIZED N/A Status message
indicating that the
ethernet interface is
processing the boot
procedure. No action is required.
ETHERNET
DETECTED N/A Status message
indicating that the
Network Interface Card
has established
connection. No action is required.
ETHERNET
INITIALIZING No Status message: the
internal Network Interface
Card is processing the
boot procedure. (May
occur with older versions
of microcode.) No action is required.
EXCESS RBN WEAR
Install New RBN Yes Status message that
displays when ribbon
reaches end of life,
whether the Integrated
Print Management
System is enabled or not. Install a new ribbon.
EXHAUST FAN FLT
(Cabinet model only)
Yes Sensors cannot detect
current in fan circuit. Power off the printer and remove
the paper path (see
Maintenance
Manual). Check that the fan cable
connector is connected. Check for
obstruction of vents and fan airway,
and remove any obstructions.
Check for items beneath the printer
blocking cabinet vents. Power back
on the printer. If this message
appears again, contact your
authorized service representative.
1
FIRMWARE ERROR* No Application software tried
to perform an illegal
printer function or
damaged memory
detected on the controller
board. Contact your authorized service
representative. 1
FM HEADER ERROR* No Frame Header Error.
Application software has
violated header
parameters. Contact your system administrator.
Table 17. LCD Message Troubleshooting Table
Displayed Message
Can User
Correct?
Explanation Solution