Ztp settings menu, Ztp function, Ztp teardistance – Printronix P7000 Cartridge Ribbon Printer User Manual
Page 333: Ztp data time, Ztp wait time
Set The Top Of Form
333
ZTP SETTINGS Menu
The ZTP SETTINGS menu includes the ability to enable and disable features
unique to the Zero Tear printer (ZTP), set the tear bar distance, set the auto
present data time, and set the auto present wait time. This section defines
these options.
ZTP Function
This option enables or disables all unique ZTP functions. The default is
Enable.
NOTE:
When the ZTP Function is enabled, the VIEW/EJECT key is disabled
and Slow Paper Slew is enabled.
ZTP TearDistance
This option sets the tear off distance from the current print position to the tear
bar. Adjustable values in increments of 1/144th of an inch range from 200 to
2880. The up and down arrows adjust the display value. When you press the
ENTER
key, the selected value is stored and a scale is printed to indicate the
current tear off position. The default value is 1060.
NOTE:
When a new value is selected, the printer will lose the current print
position. You must reset the top of form to automatically save the new
value.
ZTP Data Time
This option sets the pause time in the data stream that the ZTP requires
before moving the form to the tear bar once a print job is completed. The
values range from .5 to 15 seconds. The default is .5 seconds.
ZTP Wait Time
This option sets the minimum amount of time that the form stays at the tear
bar. This allows you time to remove the form before the form is retracted to
print the next form. The adjustable values range from 1 to 10 seconds in
increments of 1 second. The default value is 2 seconds.
ZTP
SETTINGS
1
ZTP
Function
ZTP
TearDistance
ZTP
Data Time
ZTP
Wait Time
ZTP
Platen Open
Enable*
Disable
1060/144 Inch*
.5 Sec*
1.0 - 15.0 Sec
2 Sec*
3 - 10 Sec
1 Sec
Enable*
Disable
* = Factory Default
1
Available for Zero Tear Pedestal printers only.