Printronix P7000 Cartridge Ribbon Printer - Manual (Page 110)

110
Chapter 4 NETWORK SETUP Menu
ETHERNET PARAMS
The ETHERNET PARAMS menu helps your printer communicate on a
network.
For information on assigning the IP Address, Gateway Address, Subnet
Mask, and MAC Address, refer to the
Network Interface Card User's Manual .
NetBIOS Protocol
This option determines whether the NetBIOS protocol will be available. The
selections are as indicated below:
• Enable (default). Makes the NetBIOS protocol available with the ethernet
installed.
• Disable . Makes the NetBIOS protocol unavailable during printer
operation.
ASCII Data Port
This option sets the port number for ASCII print jobs. The data port number
needs to match your host system setting.
• 9100 (default)
• 1023 - 65535
IPDS Data Port
This option allows you to set the port number for IPDS print jobs only if the
IPDS option is installed.
The range is 1023 - 65535, and the default is 5001.
Keep Alive Timer
This is the time that the Keep Alive Timer will run. With the Keep Alive Timer
on, the tcp connection will stay connected even after the print job has
terminated.
• 3 Minutes (default)
• 2 - 10 Minutes
ETHERNET
PARAMS
(from page 105)
* = Factory Default
1 If installed
2 Available for OpenPrint product only.
ASCII
Data Port
Ethernet
Speed
9100*
1023 - 65535
Auto Select*
10 Half Duplex
10 Full Duplex
100 Half Duplex
100 Full Duplex
Keep Alive
Timer
3 Minutes*
2 - 10 Minutes
NetBIOS
Protocol
Enable*
Disable
Job Control
Standard*
Enhanced
Fast Standard 2
Off
IPDS Data
Port
1
5001*
1023 - 65535