Printronix P7000 Cartridge Ribbon Printer - Manual (Page 241)

Postscript/PDF Interpreter
241
NOTE: When host jobs have page sizes that do not match the Paper Size
parameter, the printer will behave based on the Paper Size Fault, Clip
Page, and Move to TOF parameters.
Paper Size Fault
If a page is sent to the printer with dimensions that do not match the printer,
then the following will happen based on the Paper Size Fault menu selected.
• Ignore (default). The page will print and the paper size length will be
ignored. However, the width will be clipped according to the front panel
width setting.
• Fault . The printer enters a fault state and goes offline. The user will need
to either clear the fault and continue, or load new media and change the
Paper Size menu selection. Once the printer is back online, printing will
resume.
Clip Page
This menu defines the action when a page is sent to the printer with a length
that is longer than the selected paper size length.
• Enable (default). The page will be clipped at the paper size length. In
cases where the sent page is longer than the paper size length, the
“Move to TOF” menu setting has no effect since the page is clipped at the
TOF position.
• Disable . The page will not be clipped and printing continues on the next
page. The action taken by the printer when printing of the page completes
is determined by the Move to TOF menu.
NOTE: Page clipping at paper size width is always enabled to protect against
printing on the platen.
12x12 Inch 12 x 12 in
13.6x12 Inch 13.6 x 12 in
Tabloid 11x17in 11 x 17 in
JIS B5 7.2 x 10.1 in
US Folio 8.5 x 13 in
No. 10 Envelope 4.1 x 9.5 in
DL Envelope 4.3 x 8.7 in
C5 Envelope 6.4 x 9 in
C6 Envelope 4.5 x 6.4 in
ISO B5 6.9 x 9.8 in
Table 10. Paper Size Options and Actual Size
Paper Size Actual Size