Printronix P7000 Cartridge Ribbon Printer - Manual (Page 293)

Fault Messages
293
D51 Status %XX
Programming...
No Status message: The
printer is loading
firmware, where %XX
represents the
percentage completed. No action is required.
D55 Status: Send
Program to EC No Status message: The
printer is loading the
engine controller program
into the engine controller
(EC). No action is required.
DIAGNOSTIC
PASSED No Status message: the
printer passed its
memory and hardware
initialization tests. No action is required.
DO NOT POWER OFF No Status message: The
printer is performing an
operation that must be
completed before you
can cycle power. No action is required, but do not
power off the printer until the
operation is complete.
DP FIFO Busy* Yes There is a timing problem
in the Engine Controller
firmware. 1. Cycle power. Run the print job
again. If the message appears,
download the emulation
software again.
2. Cycle power. Run the print job
again. If the message appears
again, contact your authorized
service representative.
1
DRVR CIR BAD* No Driver Circuit Bad. The
hammer coil count test
failed. Contact your authorized service
representative. 1
E00 EXE @ ADDR0
See User Manual Yes An illegal or unsupported
instruction was attempted
in the application
program. 1. Cycle Power. Run the print job
again. If the message appears,
load the latest emulation
software.
2. Cycle power. Run the print job
again. If the message appears,
record the display message
and send it to your next higher
support facility.
Table 17. LCD Message Troubleshooting Table
Displayed Message
Can User
Correct?
Explanation Solution