Xantrex Technology XDC 20-600 - Manual (Page 83)

Power Supply Operation
TM-XDOP-01XN 3–21
Store User Settings
If you have a frequent or constant need for a specific voltage and current output,
you can save these setpoints in the power supply’s memory as a user setting. Once
a setting is stored, it remains in the power supply’s memory after the unit is
powered off.
Ten user setting memory locations are available, and each saves the following
parameters:
• Voltage setpoint
• Current setpoint
• Power setpoint
• Over-voltage protection setpoint (OVP)
• Under-voltage protection setpoint and shutdown configuration (UVP)
• Over-current protection setpoint and shutdown configuration (OCP)
• Under-current protection setpoint and shutdown configuration (UCP)
• Over-power protection setpoint and shutdown configuration (OPP)
• Under-power protection setpoint and shutdown configuration (UPP)
• Foldback protection mode and delay settings
• Over-temperature protection auto recovery configuration (OTP)
• AC Off auto recovery configuration (ACO)
• Aux line configuration
• Front panel display configuration
• Front panel knob lockout
• Voltage, current, and power limits
• Triggered voltage, current and power setpoints
• Trigger source
Important: All parameters are saved and used when the user setting is
recalled. Therefore, you should set parameters that you do not care about to the
factory defaults.
TM-XDOP-01XN.book Page 21 Monday, July 17, 2006 11:19 AM