Xantrex Technology XDC 20-600 - Manual (Page 253)

S
C
PI C
o
mmand S
u
mmary
TM-XDOP-01XN
C
–29
Table C-14 Auto Sequence Commands
Function SCPI Command Description Query
Delete selected
sequence [:]PROGram[][:SELected]:DELete[:SELect
ed]
The selected sequence is deleted N/A
Delete all sequences [:]PROGram[][:SELected]:DELete:ALL All sequences are deleted N/A
Select a sequence to
run or edit [:]PROGram[][:SELected]:NAME Select sequence to run or edit Yes
Change Auto
Sequence operating
state [:]PROGram[][:SELected]:STATe
{RUN|PAUSe|STOP}
Change operating state of current
auto sequence Yes
Skip to the next step
(while running in
auto sequence) [:]PROGram[][:SELected]:STEP:NEXT Skip to start of next step. Error if
STATe is not RUN N/A
Read selected
sequence number of
steps [:]PROGram[][:SELected]:COUNt? Read number of programmed
steps in selected sequence Yes
Delete selected
sequence step [:]PROGram[][:SELected]:STEP
er>:DELete
Delete the selected sequence step N/A
Exit a selected
sequence [:]PROGram[][:SELected]:EXIT Exit a selected sequence N/A
Read current step
number [:]PROGram[][:SELected]:STEP:EXECuting
?
Query current step in execution N/A
Edit selected
sequence step [:]PROGram[][:SELected]:STEP
er>[:EDIT]
[[[[[],],],
],{|TRIG}]
Edit the selected sequence step Yes
Insert step into
selected sequence [:]PROGram[][:SELected]:STEP
er>:INSert
[[[[[],],],
],{
Insert a step into the selected
sequence N/A
Program selected
sequence step
current [:]PROGram[][:SELected]:STEP
er>:CURRent
Edit/program step current of
selected sequence Yes
TM-XDOP-01XN.book Page 29 Monday, July 17, 2006 11:19 AM