Xantrex Technology XDC 20-600 - Manual (Page 240)

SC
PI Co
mmand Re
fe
ren
ce
C–16
TM-XDOP-01XN
Table C-5 Commands for Calibration
Function SCPI Command Description Query
Restore Factory
Calibration [:]CALibration[]:RESTore Restore the calibration to the
constants set at the factory N/A
Change Calibration
Password [:]CALibration[][:SECure]:CODE Change the calibration security
code. No
Set Calibration
State [:]CALibration[][:SECure]:STATe
off-state>,
Change calibration state (mode) Yes
Set Analog Current
Programming Input
Level [:]CALibration[]:ANALog:<5V|10V>:PROG
ram:CURRent:LEVel {MINimum|MAXimum}
Set analog programming current
calibration level No
Enter Analog
Current
Programming Input
Data [:]CALibration[]:ANALog:
:{5V|10V}:PROGram:CURRent[:DATA]
Set analog programming current
calibration data No
Set Analog Voltage
Programming Input
Level [:]CALibration[]:ANALog:
:{5V|10V}:PROGram:VOLTage:LEVel
{MINimum|MAXimum}
Set analog programming voltage
calibration level No
Enter Analog
Voltage
Programming Input
Data [:]CALibration[]:ANALog:
:{5V|10V}:PROGram:VOLTage[:DATA]
Set analog programming voltage
calibration data No
Set Analog Current
Readback Output
Level [:]CALibration[]:ANALog:
:{5V|10V}:READback:CURRent:LEVel
{MINimum|MAXimum}
Set analog readback current
calibration level No
Enter Analog
Current Readback
Output Data [:]CALibration[]:ANALog:
:{5V|10V}:READback:CURRent[:DATA]
Set analog readback current
calibration data No
Set Analog Voltage
Readback Output
Level [:]CALibration[]:ANALog:
:{5V|10V}:READback:VOLTage:LEVel
{MINimum|MAXimum}
Set analog readback voltage
calibration level No
TM-XDOP-01XN.book Page 16 Monday, July 17, 2006 11:19 AM