Xantrex Technology XDC 20-600 - Manual (Page 141)

SCPI Commands for Digital Interfaces
TM-XDOP-01XN 4–27
Program V,I,P
SCPI
To change setpoints:
SOUR:VOLT
SOUR:CURR
SOUR:POW
To check setpoints:
SOUR:VOLT?
SOUR:CURR?
SOUR:POW?
To set a triggered setpoint:
SOUR:VOLT:TRIG
SOUR:CURR:TRIG
SOUR:POW:TRIG
See “Triggering Commands” on page 4–36 for more information.
To check a triggered setpoint:
SOUR:VOLT:TRIG?
SOUR:CURR:TRIG?
SOUR:POW:TRIG?
To set limits:
SOUR:VOLT:LIM:HIGH
SOUR:VOLT:LIM:LOW
SOUR:CURR:LIM:HIGH
SOUR:CURR:LIM:LOW
SOUR:POW:LIM:HIGH
SOUR:POW:LIM:LOW
If the high end of the range was set to 5 volts, the command, SOUR:VOLT 10
would return an error.
TM-XDOP-01XN.book Page 27 Monday, July 17, 2006 11:19 AM