Xantrex Technology XDC 20-600 - Manual (Page 144)

Remote Operation
4–30 TM-XDOP-01XN
Over-Current Protection
T o set the Over-Current Protection level:
SOUR:CURR:PROT
SOUR:CURR:PROT:STAT
The first OCP protection command sets the protection level. The second
command lets you choose a warning alarm only [OFF] or shut down with an alarm
[ON] if the protection level is exceeded.
To check the Over-Current Protection level:
SOUR:CURR:PROT?
To check if the Over-Current Protection was tripped:
SOUR:CURR:PROT:TRIP?
Under-Current Protection
To set the Under-Current Protection level:
SOUR:CURR:PROT:UND
SOUR:CURR:PROT:UND:STAT
The first UCP protection command sets the protection level. The second
command lets you choose a warning alarm only [OFF] or shut down with an alarm
[ON] if the protection level is exceeded.
To check the Under-Current Protection level:
SOUR:CURR:PROT?
To check if the Under-Current Protection was tripped:
SOUR:CURR:PROT:TRIP?
TM-XDOP-01XN.book Page 30 Monday, July 17, 2006 11:19 AM