2 peripheral identification register (pid), Pid), Descriptions – Texas Instruments TMS320C645X User Manual
Page 99: Section 5.2
www.ti.com
5.2
Peripheral Identification Register (PID)
SRIO Registers
The peripheral identification register (PID) is a constant register that contains the ID and ID revision
number for that peripheral. The PID stores version information used to identify the peripheral. All bits
within this register are read-only (writes have no effect) meaning that the values within this register should
be hard-coded with the appropriate values and must not change from their reset state.
Figure 58. Peripheral ID Register (PID)
31-24
23-16
Reserved
TYPE
R-0x00
R-0x01
LEGEND: R = Read only; -n = value after reset
15-8
7-0
CLASS
REV
R-0x0A
R-0x01
LEGEND: R = Read only; -n = value after reset
Table 29. Peripheral ID Register (PID) Field Descriptions
Bit
Field
Value
Description
31-24
Reserved
Reserved
23-16
TYPE
Peripheral type: Identifies the type of the peripheral RIO
15-8
CLASS
Peripheral class: Identifies the class Switch Fabric
7-0
REV
Peripheral revision: Identifies the revision of the peripheral. This value should begin at 0x01 and be
incremented each time the design is revised .
SPRU976 – March 2006
Serial RapidIO (SRIO)
99