Roland Atelier AT900 - Manual (Page 62)

60
Selecting and Playing Sounds
Using the Harmonic Bar Settings of the Panel
If you’ve edited the harmonic bar settings in the screen, or if you’ve switched
Registrations so that the Vintage Organ settings have changed, you can
switch the Vintage Organ settings to the positions (settings) of the harmonic
bars on the panel (p. 56).
1.
Press the [H-Bar Manual] button.
A vintage organ screen will appear.
There are two types of vintage organ screens.
Vintage Organ Screen
When the Vintage Organ Type is “Flute”
fig.01-24.eps
The screen will show the harmonic bars.
By touching the harmonic bars and sliding them, you can adjust the volume of
each footage. The volume can be adjusted over nine steps (0–8).
When a harmonic bar is pulled out all the way (8), the volume is loudest.
When it is pushed in all the way (0), there will be no sound.
Icon Description
Vib (Vibrato) Adds a vibrato effect to the sound.
Cho (Chorus) Adds a chorus effect to the sound.
U/L/P
Touching < > cycles you through the available choic-
es, which are: Upper Vintage screen, Lower Vintage screen, and
Pedal Vintage screen.
Hold
The Vintage Organ screen will automatically close after it has
been displayed for several seconds. If you touch , the
screen will remain displayed until you touch once again.
When you touch the Vintage
Organ screen and then change
the settings, the screen is held
in that condition.
By touching the screen and
sliding your fingertip to the left
or right (horizontally), you can
adjust the volume of all
harmonic bars.
NOTE
It is not possible to apply both
vibrato and chorus
simultaneously.
AT-900_e.book 60 ページ ２００８年９月１６日 火曜日 午前１０時３８分