Roland Atelier AT900 - Manual (Page 278)

276
Troubleshooting
Problems with the Sound
Problem Check Solution Page
The volume level of the instrument
connected to ATELIER is too low. Could you be using a connection cable
that contains a resistor? Use a connection cable that does not
contain a resistor.
p. 245
Noise is heard in the sound
If there is a cell phone nearby, you
may hear noise from the ATELIER when
an incoming call or outgoing call
occurs, or during a conversation.
Keep the phone as far away as
possible, or turn off its power.
- - -
When the human voice “Jazz Scat” is
selected, playing dynamics do not
change the sound
The setting of “Initial Touch” is turned
OFF.
Turn “Initial Touch” on. p. 212
Rotary effect is not be applied
Some sounds do not allow the rotary
effect to be applied.
This is not a malfunction. - - -
Chorus effect does not apply
Some sounds do not allow the chorus
effect to be applied.
This is not a malfunction. - - -
When you release your fingers from
keys in the Lower keyboard, the
notes continue sounding
The Lower Voice [Hold] button is at
ON. Press the Lower Voice [Hold] button to
turn it off (dark).
p. 82
Sound is produced when you take
your finger off a key
You have selected a “Marimba Treml”
or “Banjo Treml” sound.
If you select a “Marimba Treml” or
“Banjo Treml” sound, a sound will also
be produced when you take your
finger off the key.
This is not a malfunction. - - -
Some keys (of certain keyboard
parts) sound strange You are playing notes outside the
recommended range of the voice.
This is not a malfunction. - - -
Bass is heard even though you are
not playing the Bass Pedalboard
The Pedal [To Lower] button or the
[Bass Split] button is ON.
When the Pedal [To Lower] button is
ON, the Bass will be sounded by the
Lower keyboard.
In the Pedal part, press the Pedal [To
Lower] button or [Bass Split] button to
turn the button off (dark).
p. 163
p. 165
When playing the same sound in the
Upper keyboard and Lower
keyboard, the volume is different
On one of the keyboards, “Initial
Touch” is turned ON.
Set the initial touch settings of the
Upper keyboard and the Lower
keyboard to both On, or both Off.
p. 212
The sound is not played correctly
If you layer the same type of sound (for
example, Strings 1 and Strings 5), or
play an octave-shifted organ sound,
the timing at which you play a note or
the phase relationship between the two
sounds may affect the way in which the
sounds are heard, but this is not a
malfunction.
You are layering sounds of the same
type (e.g., Strings 1 and Strings 5).
Alternatively, you are playing an
organ sound with Octave Shift.
This is not a malfunction.
- - -
AT-900_e.book 276 ページ ２００８年９月１６日 火曜日 午前１０時３８分