Re-recording – Roland Atelier AT900 User Manual
Page 181
179
Recording/Playing Back What You Play
Recording/Playing Back What You Play
If you made a mistake in your performance during recording
etc., you can re-record just a portion of the musical data in the
track.
If you wish to re-record with different settings for voices,
tempo, part balance, erase the recorded song (p. 180) and
re-record again. If the Control track still contains data from
before you re-recorded, the volume or sounds may change
during playback.
1.
Touch
The Rec/Play screen appears.
fig.07-04-2.eps
2.
Touch
measure (bar) when you start recording.
If you wish to start recording from the beginning of the
song, touch
3.
In the Rec/Play screen, touch
recording-standby mode.
will blink. The button indicators of tracks that are already
recorded will light.
fig.07-15.eps
Also, the [Rec] button indicator will light, and the [Play/
Stop] button will blink.
You can also enter recording-standby mode by pressing the
[Rec] button.
4.
Touch the Track button which you wish to re-
recording (button flashes).
The song data of the specified Track (with the exception
of the Control Track) will be erased as new song data is
recorded.
When the Track button is lit constantly, no song data has
been recorded on that Track.
5.
In the Rec/Play screen, touch
recording.
The metronome will sound a two-measure count, and
then recording will begin.
You can also start recording by pressing the [Play/Stop]
button.
6.
In the Rec/Play screen, touch
recording.
The track buttons which were re-recorded will change
from flashing to being constantly lit.
You can also stop recording by pressing the [Play/Stop]
button.
If you wish to keep the existing Expression Pedal data, and
record only the panel operations, you can make settings to
prevent the operation of the Expression Pedal from being
recorded (p. 213).
You can use punch-in recording (p. 187) to re-record only
the area that you specify.
Re-Recording
NOTE
blink
lit
NOTE
AT-900_e.book 179 ページ ２００８年９月１６日 火曜日 午前１０時３８分