Roland Atelier AT900 - Manual (Page 178)

176
Recording/Playing Back What You Play
You can record the performance that you play. You can also
record your performance while playing Rhythms or Automatic
Accompaniment.
fig.07-12.eps
1. Select the panel settings needed for recording
the performance.
2. Enter the recording standby mode by pressing
the [Rec] button.
The [Rec] button indicator will light, and the [Play/Stop]
button will blink.
3. Press the [Play/Stop] button to start recording.
When you press the [Play/Stop] button, the metronome
will play two measures (bars) of count-in before
recording begins.
If you wish to use Rhythm and Automatic Accompaniment as
you record, press the [Start/Stop] button instead of the
[Play/Stop] button to begin recording. Also, if the [Sync
Start] button is lit (i.e., if Sync Start is ON), recording will
begin the instant you play the Lower keyboard.
4. Press the [Play/Stop] button when you have
completed your recording.
The Track indicator where a performance song is
recorded will change from a flashing to a constant light.
When you press the [Ending] button (or [Start/Stop]
button) while recording a Rhythm performance or
Automatic Accompaniment, the Rhythm performance
and Automatic Accompaniment will stop. However, the
recording itself will continue. Press the [Play/Stop]
button to stop recording.
The Play and Stop functions can both be assigned to one of
the foot switches located on each side of the Expression
Pedal (p. 136).
You can also choose to cancel the metronome count-in
before recording starts (p. 221).
Caution
If you press the [Rec] button when a song has been selected
from the USB memory or floppy disk, the selected song will be
completely loaded into the ATELIER and the Composer will
enter into the recording standby mode. To record a new song,
use the following procedure.
1. Press the [Rec] button to cancel recording
standby.
2. Disconnect the external media.
If you’ve connected USB memory, disconnect the USB
memory from the External Memory connector. If you’re
using a floppy disk, remove the floppy disk from the disk
drive.
3. Delete the performance data (p. 180).
Re-record your performance.
fig.07-12-2.eps
If the following screen appears
fig.E-30.eps
When recording was automatically canceled because
the memory limit was reached.
Recording a Performance
2 3, 4
AT-900_e.book 176 ページ ２００８年９月１６日 火曜日 午前１０時３８分