About the adjuster (at-900), Connecting the power cord, Unplug the power cord from the ac outlet (p. 23) – Roland Atelier AT900 User Manual

Page 25

Before You Start Playing

If you feel that the ATELIER has become unstable, for example
after moving it to another location, turn the adjuster located on
the bottom of the stand’s legs as shown in the following.

• Rotate the adjustor to lower it so that it is in firm contact

with the floor. Make adjustments so that there is no gap
between the adjuster and the floor. In particular, when
placing the ATELIER on carpet, turn the adjuster so that it
is firmly in contact with the floor.

The legs of the AT-900’s bench also have adjusters. If the
bench is unstable, you can adjust its adjusters.

When turning the adjuster, be careful not to pinch your
hand.

First, make sure that the [Power On] switch at
the panel’s left side is OFF (not pushed in).

fig. 00-27.eps,fig.00-27-2.eps

Connect the supplied power cord to the AC
Inlet connector, then plug the other end into an
AC outlet.

Only use the power cord supplied with this instrument.

Whenever you do not intend to use the instrument for
extended periods of time, pull out the power cord from the
AC outlet.

About the Adjuster (AT-900)

NOTE

Connecting the Power Cord

OFF

Upper position

Power Cord

AC Outlet

AT-900

Power Cord

AC Outlet

AT-900C

NOTE

AT-900_e.book 23 ページ２００８年９月１６日　火曜日　午前１０時３８分