Roland Atelier AT900 - Manual (Page 22)

20
Before You Start Playing
1. Detach the pedal cord that is temporarily
fastened to the board on the upper part of the
Expression Pedal.
2. Connect the pedal cord to the connector
located at the right side of the Pedalboard.
3. Firmly tighten the screws of the pedal cable’s
plug.
4. Slide the Pedalboard firmly all the way back
so that it is secure and unable to move.
fig.00-21.eps
Do not remove the fastener located near the Expression
Pedal. Before transporting the AT-900, be sure to wind up
the pedal cable so that there is no slack, and attach it to the
fastener.
A PK series pedal keyboard (sold separately) can be
connected to the AT-900C.
The AC adaptor supplied with the pedal keyboard is not used.
The pedalboard will be turned on/off by the power switch of
the AT-900C, regardless of the position of the pedalboard’s
own power switch.
1. Make sure that the AT-900C and pedal
keyboard (PK series) are powered off.
2. Use the PK cable that is supplied with the AT-
900C to connect the AT-900C’s PK IN connector
to the pedalboard’s PK OUT connector.
Once the connections have been completed, turn on power
to your various devices in the order specified. By turning on
devices in the wrong order, you risk causing malfunction
and/or damage to speakers and other devices.
3. Turn on the power of the AT-900C (p. 24).
4. Make sure that the indicator on the rear panel
of the pedalboard is lit.
Play the pedalboard. If you hear the pedal part of the
ATELIER, connections are complete.
This unit is equipped with a protection circuit. A brief
interval (a few seconds) after power up is required before
the unit will operate normally.
For details on pedal keyboard settings, refer to the owner’s
manual of the pedal keyboard.
For details on attaching the pedal keyboard and assembling
the stand, refer to the leaflet that describes how to assemble
the stand.
Attaching the Pedalboard
(AT-900)
Screw
NOTE
Attaching the Pedalboard
(AT-900C)
NOTE
NOTE
NOTE
AT-900_e.book 20 ページ ２００８年９月１６日 火曜日 午前１０時３８分