Roland Atelier AT900 - Manual (Page 31)

29
Before You Start Playing
Before You Start Playing
Songs you record on the ATELIER and Registration sets you
create can be copied to separately available USB memory for
safekeeping. You can also copy songs to a floppy disk using a
separately sold floppy disk drive (p. 99, p. 128, p. 190).
You can also play back SMF music files saved on USB
memory or a floppy disk (p. 169).
Use USB memory and floppy disk drive available from
Roland. Proper operation cannot be guaranteed if other USB
device is used.
1. Connect the USB memory to the External
Memory connector.
Carefully insert the USB memory all the way in—until it is
firmly in place.
If you’re using new USB memory or floppy disk, you’ll need
to initialize (format) it on the ATELIER. For details, refer to
“Formatting a USB Memory (Format)” (p. 235).
Rotating the External Memory
Connector Holder
The External Memory connector holder rotates 90 degrees left
and right. Rotating the External Memory connector holder
allows you to avoid damaging the connected External
Memory if something happens to bump against it.
1. Grasp the External Memory connector holder
and turn it 90 degrees to the left or right.
Be sure to grasp the External Memory connector holder itself
when rotating it. Never rotate the External Memory
connector holder by holding the connected External
Memory.
Take care not to allow your fingers to become pinched
when rotating the External Memory connector holder.
Attach the floppy disk drive as shown the figure, using the
mounting holes on the ATELIER’s bottom panel.
For details of the attachment, refer to the owner’s manual of
the floppy disk drive.
1. Connect the USB cable of the floppy disk drive
to the ATELIER’s Ext Drive connector.
Using the External Memory
Connecting the USB Memory
NOTE
NOTE
NOTE
Connecting the Floppy Disk Drive
External Memory
Hoider
90 degrees
to the right 90 degrees
to the left
Ext Drive
connector
USB cable
AT-900_e.book 29 ページ ２００８年９月１６日 火曜日 午前１０時３８分