RAD Data comm IPmux-11 - Manual (Page 95)

Installation and Operation Manual Chapter 5 Configuring IPmux-11 for a Typical Application
IPmux-11 Ver. 2.00 Configuring IPmux-11 Units 5-3
To configure the manager list:
1. Display the Manager List menu (Configuration > System > Management >
Manager list ), and enter IP parameters for the network manager station:
NMS IP address – 192.168.10.100
Manager location – Network-Eth1.
2. Save the changes.
Configuration>System>Management>Manager list
1. Manager IP address ... (192.168.10.100)
2. Manager location > (Network-Eth1)
3. Link up/down trap (Disable)
4. Alarm trap (Disable)
5. VLAN tagging (Disable)
>
Please select item <1 to 5>
ESC-prev.menu; !-main menu; &-exit 1 Mngr/s
Figure 5-3. Configuring Network Manager
Configuring E1 Parameters at the Physical Layer
To configure E1 parameters at the physical layer:
1. Display the TDM (E1) Configuration menu (Configuration > Physical layer >
TDM (E1)), and configure the following parameters:
IPmux-11 (B) transmit clock source – Loopback
IPmux-11 (A) transmit clock source – Adaptive
Line type – Framed G.704 CRC.
2. Save the changes.
Configuration>Physical layer>TDM (E1)
Channel ID (1)
Restoration time >(CCITT)
Signaling mode (CAS Disabled)
1. Admin status (Enable)
2. Transmit clock source >(Adaptive)
3. Rx sensitivity (Short haul)
4. Trail mode (Termination)
5. Line type >(Framed G.704 CRC)
6. Idle code[0 - ff] ... (7E)
7. Send upon fail (OOS Code)
8. OOS Code[0 - ff] (FF)
(N)
>
Please select item <1 to 11>
ESC-prev.menu; !-main menu; &-exit 1 Mngr/s
Figure 5-4. Configuring E1 at the Physical Level for IPmux-11 (A)