RAD Data comm IPmux-11 - Manual (Page 74)

Chapter 4 Configuration Installation and Operation Manual
4-16 Configuring IPmux-11 for Operation IPmux-11 Ver. 2.00
To configure T1 interface:
• From the TDM (T1) menu, configure the following:
Admin Status:
Enable (T1 link is enabled)
Disable (T1 link is disabled)
Transmit clock source:
Adaptive (Adaptive clock regeneration)
Loopback (E1 recovered Rx clock is used as the Tx clock)
Internal (Tx clock is received from an internal oscillator)
System (System clock is used as the Tx clock)
Rx sensitivity (Maximum attenuation of the receive signal that can be
compensated for by the interface receive path):
Short haul (-10 dB)
Long haul (-32 dB)
Trail Mode (Enables the end-to-end transfer of TDM OAM (Operation,
administration, and maintenance) data in framed mode, when the payload
format is set to V2.
Termination (Trail mode is disabled; the TDM networks function as
separate OAM domains)
Extension (Trail mode is enabled; OAM data is passed between the
TDM networks)
Line type (T1 framing mode):
Esf (24 frames per multiframe)
SF (D4) (12 frames per multiframe)
Line code (Line code and zero suppression method used by the port):
B7ZS
B8ZS
AMI
Line interface:
DSU (DSU interface)
CSU (CSU interface)
Line length (DSU mode only, length of a cable in feet between the
IPmux-11 T1 port connector and the network access point):
0–133
133–266
266–399
399–533
533–655