RAD Data comm IPmux-11 - Manual (Page 44)

Chapter 2 Installation and Setup Installation and Operation Manual
2-4 Connecting IPmux-11 to Power IPmux-11 Ver. 2.00
2.6 Connecting to the External Clock Source
IPmux-11 is connected to the external clock source via a balanced RJ-45
connector designated EXT CLK. Refer to
Appendix A for the connector pinout.
CONTROL
EXT CLK E1
ETH
1 2 3
SET
DEF
Figure 2-5. EXT CLK Connector
To connect to the external clock source:
• Connect IPmux-11 to the external E1 or T1 clock source using an appropriate
cable.
2.7 Connecting to the ASCII Terminal
IPmux-11 is connected to an ASCII terminal via a 9-pin D-type female connector
designated CONTROL. Refer to
Appendix A for the connector pinout.
CONTROL
EXT CLK E1
ETH
1 2 3
SET
DEF
Figure 2-6. CONTROL Connector
To connect to an ASCII terminal:
1. Connect the male 9-pin D-type connector of CBL-DB9F-DB9M-STR straight
cable available from RAD to the CONTROL connector.
2. Connect the other connector of the CBL-DB9F-DB9M-STR cable to an ASCII
terminal.
2.8 Connecting IPmux-11 to Power
IPmux-11 accepts either 110–240 VAC or -48/-60 VDC power through the same
power inlet.