RAD Data comm IPmux-11 - Manual (Page 12)

Quick Start Guide Installation and Operation Manual
2 Configuring IPmux-11 IPmux-11 Ver. 2.00
Configuring the IP Management Parameters
The host IP address, subnet mask and default gateway IP address must be
configured via an ASCII terminal.
To configure the IP management parameters:
• From the Host IP menu (Main > Configuration > System > Host IP), select
an IP address of the IPmux-11 host.
Configuring E1 and T1 at the Physical Level
E1 and T1 interface must be configured at the physical level first.
To configure E1 and T1 at the physical level:
• From the TDM Configuration menu (Configuration > Physical layer > TDM
configuration ), configure the necessary parameters of the E1 or T1 services.
Configuring Bundle Connections
The E1/T1 timeslots must be assigned to a bundle. The bundle must be sent to the
remote IP address and be connected to one of the destination bundles.
To assign timeslots to a bundle:
• From the DS0 Bundle Configuration menu (Main > Configuration >
Connection > DS0 bundle configuration), assign desired timeslots to a
bundle by setting them to 1.
To connect a bundle:
• From the Bundle Connection Configuration menu (Main > Configuration >
Connection > Bundle connection configuration), set the following:
Destination IP address
Destination bundle.
Configuring the Internal Bridge
To configure the Ethernet policy for the internal bridge ports:
• From the ETH Policy Configuration menu (Main > Configuration > Bridge >
Bridge policy configuration ), do the following:
Specify bridge port operation mode
Set default VLAN ID
Set default VLAN priority
Select rate limit for each port.
To configure VLANs for the internal bridge ports:
• From the VLAN Table Configuration menu (Main > Configuration > Bridge
> VLAN table configuration), assign VLANs for each bridge port, if necessary.