Configuring ethernet interfaces – RAD Data comm IPmux-11 User Manual
Page 76
Chapter 4 Configuration
Installation and Operation Manual
4-18
Configuring IPmux-11 for Operation
IPmux-11 Ver. 2.00
Configuration>Physical layer>TDM (T1)
Channel ID
(1)
1. Admin status
(Enable)
2. Transmit clock source
>(Adaptive)
3. Rx sensitivity
(Short haul)
4. Trail mode
(Termination)
5. Line type
>(ESF)
6. Line code
>(B8ZS)
7. Line interface
>(DSU)
8. Line length (feet)
>(0-133)
9. Restoration time
>(TR-621 (10 seconds))
10.
Idle Code[0 - ff]
... (7E)
(N)
>
Please select item <1 to 16>
ESC-prev.menu; !-main menu; &-exit 1 Mngr/s
Figure 4-16. TDM (T1) Menu (Page 1)
Configuration>Physical layer>TDM (T1)
...(P)
11. Send upon fail
(OOS Code)
12. OOS code[0 - ff] ... (FF)
13. Signaling mode (Robbed Bit)
14. OOS signaling > (Space)
15. Mark signaling code[0 - f] ... (D)
16. Space signaling code[0 - f] ... (1)
>
Please select item <1 to 16>
ESC-prev.menu; !-main menu; &-exit 1 Mngr/s
Figure 4-17. TDM (T1) Menu (Page 2)
Configuring Ethernet Interfaces
IPmux-11 includes one network and up to two user Ethernet ports.
To configure Ethernet interface:
1. From the Physical Layer menu, select ETH.
The ETH menu appears (see
2. From the ETH menu, type F to select the Ethernet interface that you intend to
configure (Network-Eth1, User1-Eth2 or User2-Eth3).